6" Carbon Fiber Rebar Pins
$39.95
Skip to product information
6" Carbon Fiber Rebar Pins
$39.95
Install your 18" fiberglass rebar pin too far into the basin wall and can't get at it to secure the CFRP Fabric? Follow it with a 6" CFRP Rebar pin into the same hole. Make sure to keep 1/2" to 1" out of plumb with the wall surface to secure the CFRP fabric around or through it.
Set of four (4) replacement 6" CFRP pins (6 pictured).
- Fiberglass Rebar support pins are an integral part of the BASIN-SAVER system. However, these 6" CFRP Rebar pins can be a life saver if the 18" pin disappears into the basin wall during installation.
- The pins reduce the likelihood of installer error by supporting the BASIN-SAVER fabric lining in case of poor adhesion or adhesion failure to the concrete walls.
- 100% corrosion resistant when saturated with structural epoxy resin and waterproofing membrane.
- Measurements: 3/8" dia x 6" long